Jump to content
AVIC411.com

gggplaya

Members
  • Content Count

    61
  • Joined

  • Last visited

Everything posted by gggplaya

  1. Perhaps it's a bad crimp or solder job on that wire. I use the microbypass and play videos all the time, i use it to change videos for the rear overhead monitor, but it plays up front as well, I just use the mode button to blank out the screen while i'm driving.
  2. You should install one of these, a microbypass: https://www.amazon.com/MicroBypass-Automatic-Interface-AVH-4100NEX-AVH-4200NEX/dp/B00VKQ6ECQ
  3. What performance problems???? Mine works great, except android auto sometimes needs me to unplug and plug it back in, initially.
  4. I think the password thing is just a waste of time. Even if you had a light to denote an active password, most theives aren't that smart to know the intricacies of each type of head unit. I feel like they'll still rip your dash apart as fast as you can, take the head unit home and try to hook it up, only to find the password is there and it's useless. However, the damage and loss to yourself is already done, so really the only thing a password does is ensure that everyone loses, instead of just you. I have the 4200nex, it's a good unit and I do take the faceplate off in questionable nei
  5. I installed a remote start on my car, it also starts the vehicle 12v power roughly 3-4 seconds before it cranks the engine. But i've never experienced anything like yours on my 4200NEX.
  6. I'm not capable of trying this without some kind of custom rom to disable the lock the AA lock screen. Sorry man.
  7. You head unit currently thinks it's in reverse, because you selected to have the camera activate on either an active high or active low signal. The camera being installed doesn't matter. Take the reverse signal wire on the back of the head unit, and wire it to either ground or 12v until it parking lines are gone and the normal display appears. Then change the setting back and rewire it back.
  8. Are you trying to play movies to monitors in the back of the vehicle?? Just select the back seat icon and select the source. It's not automatic when you play a video in the front.
  9. I've had the 4200nex for over 2 years, and I've only used the motorized face less than 12 times. I only use it to add more content to the SD card. But so far, no issues with it. If you plan on constantly swapping CD's, then I would find reason to worry depending on how long you want it to last. But i've had car decks with motorized faceplates and CD's, and never had any issues back in the day for years, back when CD's were popular.
  10. I would check with the nissan forum as they would know the car better than any of us. If there is a harness available, and the dimensions of the radio fit, I don't see why you couldn't.
  11. Carplay allows you to still use the phone while using carplay, I wish android would do the same.
  12. The only difference between the 8200nex and the 8201nex is the backup camera comes packaged in the box with it. If your car already has a backup camera, you wouldn't buy the 8201. In fact, the head unit inside the box of an 8201 package is actually still labeled 8200nex. Android auto and apple car play work just as well as a factory head unit with AA/carplay built it. The speed of AA/carplay is actually dependant on your phone since the software runs on there, and the pioneer head unit is just an interface. I've never had a bluetooth issue with my 4200nex. The differences betw
  13. Yes, I'm using a raspberry pi on my 4200nex to play movies. But I don't know how you would get the touchscreen to interface with the pi. I just use an RF remote ( https://osmc.tv/store/product/osmc-remote-control/ ), the remote works perfectly and has lasted the test of 3 summers and winters in the car 24/7. I don't know about the 8200nex, but on my 4200nex the highest resolution I could set the pi to was 576p, which still looks awesome on such a small screen.
  14. Yep as said, 480p input or I was able to get 576p to work on my Raspberry PI. But that's about the highest it'll go in terms of resolution input signals. I was able to get a 1st gen Chromecast to work, which goes down to 480p. What sucks is on my last car I had a cheap DUALAV (DV625BH) head unit which took my Raspberry Pi 1080p signal and downscaled it without any issues. Seems like a huge oversight on pioneers part. If you want to use the Micca Media Player, you'll need to convert it to RCA input with https://www.amazon.com/VAlinks-Composite-Converter-Adapter-Blue-Ray/dp/B01M1
  15. Most consumer grade electronics have a thermal limit of 150F. That pertains to things like capacitors, regulators, and ARM processors etc...... Most head units have heat sinks and thermal holes on the chassis, some have fans in the back. You could buy something like this and install it under the head unit somewhere, or in a side panel inside the dash that leads to your footwell, as long as you can get air behind the head unit. Just cut a hole and screw this one in, it'll look like a clean install. https://www.amazon.com/AC-Infinity-AIRPLATE-Cooling-Cabinets/dp/B009COAEUG/ref=sr_1_8?i
  16. I had the opposite experience. I have an iphone but bought a $100 android phone so I could use an SD card and load up all my spotify playlists. Then I discovered that I like android auto better. The coverart looks much nicer while using spotify and while navigating, it'll give a pop-up window showing the song for a few seconds after it's changed. Waze is also in beta earlier this month, so won't be long until all the bugs are worked out and they can go to a full release. https://www.engadget.com/2017/06/07/waze-android-auto-beta/
  17. You have a defective unit, it shouldn't be that slow. Mine's responsive and fine and volume button presses are always instantantaneous. Also, once in carplay, the speed is actually dictated by the generation of iphone, because the software actually runs from the phones processor. But volume changes have nothing to do with the phone, which leads me to believe your unit is defective.
  18. Probably depends on how you format your SD card.
  19. Waze for android auto is in closed beta testing right now. Won't have to use an hdmi cable for much longer. The already added the map submenu to android auto. It was in WAZE's beta program in april, now it just entered android's beta program. https://tech.blorge.com/2017/06/04/busting-traffic-waze-beta-release-android-auto-beta-testers/158249 But to your point, I have a 4200nex and the apps don't look washed out at all, they look as good as they do on my phone.. Are you sure you set your brightness and contrast levels correctly???
  20. Try movies from the SD card slot. Also make sure your phone is not connected to the head unit while playing movies. I have the 4200nex with an overhead monitor installed. Unfortunately mine doesn't have speakers or infrared, so I can't try it for you.
  21. Wait so you're saying it works fine going directly to the head unit and not using the pioneer cable? You're only complaining about the pioneer cable?
  22. It's called "HDCP", it's not specific to the iPHONE but something done by the app itself. It basically protects the movie and tv content from being recorded by an external recorder. What I do with my pioneer 4200nex is use a chromecast to play netflix. Not sure if the directTV app works with that.
  23. You can take pioneer's specs and basically throw it out the window. For instance, I"m using a large 256GB PNY SD card to play movies to a rear overhead monitor. The sole reason for choosing the pioneer was because it allows you to do this, as well as select other sources to play to the rear. Also, for reference, the highest resolution I can seem to pump into the pioneer's HDMI from my raspberry pi is 580p video. But to your question. I'm using wondershare video converter ultimate to batch encode my videos, I have a fully loaded 256gb SD card, loaded with MP4 videos. I use wonde
×
×
  • Create New...