Prlauren

I recently went on a few trips this summer. The same trips were taken again. I set the ones I frequent often as my favorites. The learning function was set to "ON". When I made the same trip again the GPS Routes me a different way.....It's not learning the way I normaly go. Any Ideas or suggestions?. I also shut road conditions "Off" and they still pop up during my route if theres traffic. Don't understand why. I also Owned several other Pioneer navigation units in the past. This unit the Avic-Z150BH hast trip route: Fast, Short, & Main road. My other radios did not have Main Road......is

Did you try setting unit to Av 2 ?

Well This Has been In my truck for more then a week now with Bypass and only had annoying bypass incorrectly installed twice so far and all is good. Except for the background noise I hear with my ipod touch.

I moved mute wire over very easy. I made sure it's connected properly and I have it grounded with green bypass wire to a good ground. I Have Pin Connected. I do not have a wire Jammed in.

Do you have the speed sensor hooked up? I don't have mine hooked up and I've only seen the warning twice so far. I couldn't find the speed sensor in my truck during install, but I know where it is now so i will be hooking it up this weekend & I will let you know if it becomes an issue. I'm wondering if the speed sensor has anything to do with it.

I Have this installed with Bypass using the x950BT mod. First impression........Love it. I sold my Avic z120BT because I hated it so much. My first impression of the Z150, much better lay out. OS very fast no lag like on the 120BT. I have not used it much to comment on anything else but give me a month and I will. The bypass works but not flawlessly. After installing it about 3 miles of use the screen gave me a warning that the brake bypass was not installed correctly. I just hit ok and movies still work while driving. I installed it on Saturday and that error showed up. Then this morning (Mon

Bypass Worked using the same Mod as X850BT. Everything works fine but I have two issues. 1st issue is the warning for the parking brake came on about 3 miles after my install....I pressed "OK" and it was still fine to watch movies while driving. This all was installed on a "Saturday". This Morning "Monday" on my way to work The warning Info popped on the screen again...Hit "OK" and everything was still ok. 2nd issue I have is: while watching any movies from my ipod touch I get feedback noise through speakers & can't understand why? Radio is fine, XM is Fine but only when watching a movie

LOL.....Only messing with a noob.....I still didn't recieve mine from crutchfield yet when it comes in an I hook it up an do the X850BT hack an fry it I'll let you know.

Did you wear a helmet and take the little yellow school bus???

That's great news! So it's the same mod as the x850bt is that correct?

I just purchased this unit an I should have it buy the 27th of this month. I don't want to install it until I have the bypass. Nobody else tried this yet and had success for sure?

Sorry if this may be a stupid question but I have the Avic-X930BT and I'm trying to do the bypass with the mute wire and I can't remove the pin without destroying the plug. Any advice or instructions to do this properly?

Can Anyone Tell Me If You Can Connect A USB Hub To The Z120BT? If So Can Anyone List The Ones That Were Success Full?

Damn! That's easy.....I was cycling through settings and everywhere else. Should have known better but was use to avic-z2

I Purchased and have been using my Avic-Z120BT But I can't seem to find the setting for mileage. I use to have a Z2 and when you pluged in your route in the upper corner it would give you the mileage to your destination. The Z120BT only shows in the top right corner estimated time of arrival. Does it have a setting somewhere that I am missing for the mileage.......or it does not have this feature?