My 2007 Mustang came with a Shaker 1000 headunit and no steering wheel audio controls.
I swapped the Shaker OEM unit with a Pioneer AVIC-Z120BT unit. I am swapping my factory steering wheel for a 2012 unit that does have volume controls.
Is it possible to wire the steering wheel controls into a remote for the AVIC unit?
My guess is the harness connections for wheel controls would have to be in place, which I am not sure if they are or not. Otherwise how would the signal pass from the wheel through the clock spring?
Any help would be greatly appreciated. Thanks!
I was tooling around with my F90BT and found a live speed read out under the satellite info/strength panel.
Is there any place on the Z120BT that will give a real time read of the speed of the vehicle? I would like to verify my speedometer changes.
Thanks!
I picked up a Boyo VTK350 and an Audiovox CMOS-2 in hopes of dropping them in from the outside and threading the collar onto the camera from the inside.
Both are too large. The Audiovox is very close, but still about 1-2mm to wide. I guess I will need to build a bracket to mount it from the inside.
I am trying to install a backup camera in my trunk lock keyhole just like this, same car - 2007 Mustang:
viewtopic.php?f=33&t=24868&p=186793&hilit=keyhole#p186793
What camera would fit?
I picked up a Boyo VTK-350 'keyhole' camera but it is a little too wide for the hole.
http://www.sonicelectronix.com/item_154 ... K-350.html
Hello,
I installed an F90BT awhile ago using the larger Metra harness for my 2007 Mustang, so I did not need to tap into anything around the car.
I'm about to replaced it with a new AVIC as well as add the XM unit. Where is the best place to get a constant 12v source for the XM unit?
thank you
Coupon Code still works, but won't ship it to me in CA.
It says find a store for pickup, but it won't let me complete the transaction this way.
Will the stores honor the coupon?
Hey guys, newb here.
Just wired up my F90BT last night. I moved the Mute wire and grounded it along with the Parking Brake wire.
As of right now I don't have my VSS (Vehicle Speed Sensor) wire connected out of the assumption that it would defeat the bypass.
Can I connect this? Or shall I leave it as is?
Thank you!