joe r

As long as you followed the install instructions you should be golden. joe r

Reverse Light yellow/red + passenger kick, harness to rear. joe r

What did you find out about your deck dimming? joe r

No worries. Thanks again for your time & patience. joe r

WOOHOOO! I even staid up till 11:30pm last night awaiting your call back but no worries.I am glad we got it worked out!!! joe r

I didn't realize he had hacked into his HDD & installed these. I thought that these were there & just pop up in 3d mode when your in a bigger city.My Z2 would only go into 3d map mode in Seattle or Tacoma. I live in Wenatchee.it doesn't do it here. Sorry that I am not as smart as some of you posters & sorry about the high jack of the post. joe r

Wow I don't think I ever noticed the sun or moon on my Z2.I almost want to pull it out of the box & power it up just to check these out. Thanks for the pics. joe r

Also if need be you have a pm.I am up till about 11pm. joe r

Middle plug its the big plug.Thats on my wifes 04 Forester XT. joe r

Yes as soon as you start to drive it will change speed pulse on screen. I grabbed my wifes 04 Forester XT speed sensor wire at the gauge cluster & it was yellow/green wire. Also if you pull the gauge cluster make sure you don't power up the car with it unplugged or you might get an abs/airbag or check eng light. joe r

Also don't get mad we will get you thru this! If need be pm me & I can send you my cell # to chat. joe r

If all else fails pull your gauge cluster.Very easy unless you have the crappy factory boost gauge. Pull steering wheel down to lowest setting,deinstall 2 screws above gauges & pull gauge cluster cover out.deinstall 4 screws holding gauge cluster to dash.pull gauge cluster out of dash & find wire colors listed above.It should be the green/yellow at gauge cluster. Your pic is a tad blurry. joe r

Speed Sense green/yellow or green/black ECM below glove box On the non-turbo models the vss is in pin 12 of the 35 pin plug. On the turbo models the vss is in pin 13 of the 35 pin plug. On the STi models the vss is in pin 26 of the 35 pin plug. The vss wire is also found behind the instrument cluster. Count pins & check for wire colors above. joe r

Or tap it & drive around the block.Your z2 only is a reciever. But yes you can use your multi meter & test it also. joe r

Pm or e-mail me if needed.If not post in this thread & I will try to reply ASAP... joe r