Jump to content
AVIC411.com

mykal41

Members
  • Content Count

    10
  • Joined

  • Last visited

About mykal41

  • Rank

Profile Information

  • Location
    Long Island
  1. power and ground are the same. I have the ground to the chassis right now. Its a good clean ground. I am going to increase the radio ground size today. Maybe I will just add a good chassis ground to the radio ground. How about grounding the little wire that runs with the rca's. Just throwing things out there.
  2. I used the can bus adapter to install my d3. Do you guys use that ground or ground the radio to something better.
  3. I switched the ground around, I even went as far as to run a cable to the batt for the neg. I swaped the amps ( highs and subs) They both make the noise, However with the low pass filter on the noise is gone. I retraced my wiring on the radio. No power wires cross rca or speaker wires. I added a ground to the radio itself. still no help. by no means am I an installer, But I am not an idot. I am just looking for some friedly advice. Do they make a filter of sorts that would fix this.
  4. It makes the noise with volume down.... engine off
  5. All hooked up. D3, kicker sx650 amps, 2-kicker vr-10,.6x9's, 5 1/4's. I used a dual amp kit, I have an engine noise with no volume. It sounds like my fuel pump. Should I move my groud.
  6. I used the metra xsvi-6502 and it had no provision for the vss or reverse or dimmer. I searched and I cant find any info on the 06 cummins auto tranny. Could you provide a link.
  7. 2006 dodge ram cummins vss. ANybody know where I can tap in. I used a metra harness that crutchfiel sold me and it has no provision for the vss , reverse, dimmer. It cant be to hard to wire these three things. Any help would be great..
  8. I used the metra adapter. I did not provide me with the vss or reverse wire. Unless I am missing something. no wires unhooked
  9. 2006 dodge ram cummins no factory nav. Anyone know where the vss is in this truck. Also a good place for the reverse wire . The dimer wire needs a home too.
  10. Installed the d3 last night. I used the metra-xsvi-6502. I cannot find a location for the vss wire , reverse wire and the dimmer. Is there any way to hard wire these wires without changing adapters. Also I did the hack, And on start up I get a message that states the parking break was not hooked up correctly. Is this normal. Any help would be appreciated.
×
×
  • Create New...