Search the Community
Showing results for tags '940BT'.
Found 4 results
-
I have the latest firmware, 5.1 and 2015 maps. I Decided to install my CD-IV202NAVI kit and as long as the module is powered up, i get a nag screen that says my parking brake sensor is connected wrong blah blah blah... If I disconnect the power to the module, it goes away and works like it always did. It's like the new module can see that I'm bypassing the parking brake sense wire. By the way, I'm using the mute wire to pin 1 of the white harness and grounding both the mute wire and parking wire like I was instructed to. (Net install instructions!). Worked for years. Also, it seems that my iP -
I've installed the 940BT by following the bypass video seen here: Great bypass trick but my video still cuts out when I reach a speed above 15mph because of the GPS Nav unit. If I unplug the nav cable from the back it works perfect and I'm not restricted. Anyone figure out how to bypass the GPS from knowing you are in motion? Thanks!
-
So I have done alot of reading and didnt come across the answer I was looking for. Im looking to do the bypass mode for for the new 940BT and it seems to me that all of the videos I have seen say that they are different from the 930. Is this correct or am I just slow. Thanks in advance
-
Hi everyone! - Yes, i dont have an Iphone ! Im trying to have album cover image to display when played from SD card, folder have .jpg image - but it doest'n appear - any ideas? Thanks!
