IrishPilot Posted March 22, 2010 Report Share Posted March 22, 2010 Been watching this... And I have this... http://cgi.ebay.com/PIONEER-DVD-BRAKE-BYPASS-HACK-AVH-P5200BT-AVH-P5200DVD_W0QQitemZ130369230584QQcmdZViewItemQQptZLH_DefaultDomain_0?hash=item1e5a9c96f8#ht_717wt_1165 and have been trying to figure out how to get it all set up properly. Im trying to have it all down in my head before I go tearing the HU out to get at the wiring. My questions are... [*]Is it necessary to disconnect the battery first? [*]What changes if I have amps hooked up? Anything? The directions on the bypass say to... [*]hook the blue wire to the remote turn on wire on Pioneer HU (blue with white) [*]hook the black wire to ground wire on Pioneer HU (black) [*]hook the green wire to the brake wire on Pioneer HU (light green) The headunit is already installed, so what do I do with the current connections? I would assume the remote turn on wire is currently connected to a wire running the amps etc. right? So do I just disconnect it and ONLY connect the relay and the remote turn on wire on the HU? Wont that eliminate the amp turn on? As you can tell, I did not do the HU install myself but would like to get this relay setup. Any insight or direction would be greatly appreciated. Thanks! Quote Link to post Share on other sites
maxzboy Posted May 10, 2010 Report Share Posted May 10, 2010 check out www.avhbypass.com Quote Link to post Share on other sites
rgarjr Posted May 12, 2010 Report Share Posted May 12, 2010 The blue/white wire (REMOTE TURN ON) on the head unit needs to power up the by-pass relay as well as turn on the aftermarket amps. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.