newvet Posted February 6, 2007 Report Share Posted February 6, 2007 I have the gex-p10xmt connected to the z1 via the ip-bus cable and the data cable. the z1 xm status screen reads not connected and no signal. I have reset the Z1 and the xm nav module and It still wont work. I did not connect the Power supply plug as the directions said it was not needed. Any suggestions. Thanks Quote Link to post Share on other sites
cntrylvr79 Posted February 6, 2007 Report Share Posted February 6, 2007 You only need to post once. Quote Link to post Share on other sites
newvet Posted February 6, 2007 Author Report Share Posted February 6, 2007 that was my first post ever. Mix up maybe? Still any help would be welcome. thanks Quote Link to post Share on other sites
cntrylvr79 Posted February 6, 2007 Report Share Posted February 6, 2007 My bad another member posted pretty much the exact same question. At any rate your answer is right here. http://avic411.com/forum/viewtopic.php? ... highlight= Quote Link to post Share on other sites
newvet Posted February 6, 2007 Author Report Share Posted February 6, 2007 thanks a million- I just got back in from hooking up wires exactly as the post you directed me to. Pioneer took a while but got that info to me also. thanks again Quote Link to post Share on other sites
cntrylvr79 Posted February 6, 2007 Report Share Posted February 6, 2007 Cool glad it worked out for you. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.