Jump to content
AVIC411.com

Avic n1 fold out problems not ribbon related


Recommended Posts

Brand new to the forum hope I did not miss anything in the search under this topic so here goes. Just purchased a repo vehicle with avic n1 and no faceplate so i rolled the dice and purchased a new faceplate for $70 long story short everything works except the screen mechanism so I hit open and gently pulled and it motored out and flipped up. Opened the unit up in hopes of finding a bad ribbon cable but instead found the actual problem with this unit. There is a drive shaft that goes from left to right with 3 gears on it, the innermost gear is cracked and seperating causing it to bind up every revolution until you manually pull it past that point, I removed the gear and slid the screen back in the chassis and it moves freely with no binding. I have exhausted the internet in search of this gear and will be calling pioneer to see if I can track this down but in the past I have had a hard time finding this type of thing without a part number and was hoping someone here might know what i am looking for, Also when taking the unit apart I slipped cutting the tape off the cover of the monitor mechanism and accidently ruined the ribbon, what is the best place to purchase the ribbon, I see it is discontinued from pioneer and everyone on ebay has it marked up 100%

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...