dvboy Posted August 12, 2016 Report Share Posted August 12, 2016 Quick question,when using my steering wheel control to go up/down for radio stations on my 8000nex,it scans up and down and doesn't go from station to station?Is there a way to make it jump to my next saved station and not scan?? Quote Link to post Share on other sites
vietnight Posted August 18, 2016 Report Share Posted August 18, 2016 Quick question,when using my steering wheel control to go up/down for radio stations on my 8000nex,it scans up and down and doesn't go from station to station?Is there a way to make it jump to my next saved station and not scan?? try press and hold, it have dual mode that is what i have setup on my maestro Quote Link to post Share on other sites
Parrothead1809 Posted September 5, 2016 Report Share Posted September 5, 2016 It may also depend on if you have a steering wheel module between your controls and the head unit. I have an older Axxiss ASWC-1 (that I recycled from a prior installation). As far as I can tell, it just cycles the channels from my pre-sets. Press-and-hold, just cycles them faster -PH Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.