amp3d Posted December 6, 2016 Report Share Posted December 6, 2016 Hey folks Quick question for the pros out there coming from the avic-z series. I've had a few avics over the years, and the last couple ones used the same wiring harness. That allowed me to install my z130 without having to resolder the wires. I don't mind doing that, but to be honest I sometimes drive down south of the border (I'm canadian) and do a swap before coming back over the border to help with customs Just wondering if I need to take my soldering stuff with me, or if the new nex8100 will use the same wiring harness as my z130? Thanks for your time! Quote Link to post Share on other sites
gggplaya Posted December 20, 2016 Report Share Posted December 20, 2016 I'm looking on ebay at the harnesses and they appear similar, but the flap for the fuse is on the left side of the 8100nex harness, whereas the flap is on the bottom side for the Z130 harness. They both appear to have the same 16 pin configuration though. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.