Gregavi Posted January 11, 2018 Report Share Posted January 11, 2018 I have an Pioneer AVH 4200NEX that I have configured as follows: Front Pre Out into my Power amp Front Inputs Sub Pre Out into my Power amp Sub Inputs Rear speaker level out from NEX connected directly to my rear speakers. I have the NEX set to ON for Rear Speakers ON/OFF selection. My rear speakers are barely audible in this setup. Is there some other setting on the NEX that needs to be set in order for these rear speakers to play at a reasonable volume? I understand that the Pre Outs to a power amp for the fronts is obviously going to produce more volume, but I expected to have a reasonable amount of volume from the rears. Even if I "Fade" the balance all the way to the rears, they are still barely audible and if I crank up the rears with the balance all the way to the rears, I get a bit more volume but it starts to distort more than I would expect. Any help is appreciated. Thanks in advance. Quote Link to post Share on other sites
josney Posted January 12, 2018 Report Share Posted January 12, 2018 do you have it in network mode? maybe switch it to standard. Quote Link to post Share on other sites
Gregavi Posted January 13, 2018 Author Report Share Posted January 13, 2018 do you have it in network mode? maybe switch it to standard. I don't know. Didn't know there was such a mode. I'll check. Thanks. Quote Link to post Share on other sites
Gregavi Posted January 13, 2018 Author Report Share Posted January 13, 2018 Apparently the 4200 does not have Network Mode. Any other ideas? Quote Link to post Share on other sites
josney Posted January 14, 2018 Report Share Posted January 14, 2018 sorry to send you on a wild goose chase. it was the first thing that came to mind. what kind of car? factory amp installed? using a harness of any sort? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.