hmgrts Posted November 30, 2007 Report Share Posted November 30, 2007 My deck is overheating up to the point where the buttons on the touch screen are shifted. I can't get to the buttons on the left. Whenever I try to push the buttons on the left, it ends up pushing the button that was next to it. I reseted to factory settings but that didn't work. I booted it into a special service menu. But I'm not able recalibrate AVIC D2 screen through service menu - pictures below. Is there other way how I can fix it? Quote Link to post Share on other sites
POTERAN Posted January 8, 2008 Report Share Posted January 8, 2008 how do you get to that menu again so i can try it. I have the same problem. Quote Link to post Share on other sites
shoman94 Posted January 8, 2008 Report Share Posted January 8, 2008 Follow the instructions....it works fine. Quote Link to post Share on other sites
sekoh69 Posted January 29, 2008 Report Share Posted January 29, 2008 instructions dont say how to get there. i have the D2.........can you plz help me. Quote Link to post Share on other sites
doowah2000 Posted March 10, 2009 Report Share Posted March 10, 2009 I know that this is an older thread but I had the same problem and found a solution that worked for me. Maybe it will help others. When in the service menu and you are told to trace the white line make sure that you trace it as well as posible on the top and the bottom, but on the sides, intentionally trace 1/4" away from the line toward the center of the screen. I had to do this 5 or 6 times to get the distance correct, but now that it is the screen calibration works perfectly and I can accurately click on any button in the regular menu. Fo those trying to get to the service menu follow the instructions here: http://www.avic411.com/forum/viewtopic. ... rvice+menu One other thing that I am sure is obvious to most, but may not be to all: I bought a car that had this unit in it so I have no experience with it and no manual, so for those of you that may not know there are two disk slots. If you press the open key it will only show you the CD drive, but if you HOLD the open key it will continue to open and show both the CD drive and the NAV DVD drive. It is the NAV DVD drive eject button that gains you access to the service menu. I hope that this helps someone out there. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.