Zroe

So, I figured it out. What I had done, was trace the wire from my rear passenger light (white with grey stripe) all the way to the passenger wire harness under the glove box. I spliced into the white with grey stripe wire there. Low an behold, not all white with grey stripe wires are the same! Today, I ran the wire directly to the far back rear passenger light and ran it all through the carpet, etc. It now works flawlessly. Thanks for the replies.

I have already run the puprle wire straight to my reverse light and it still doesn't register. The settings are all correct: reverse is on and camera is set to battery. I have not tried connecting a 12V wire to the purple wire yet, I'll try that next and update here. Thanks

Hello all. Question about my installation. 8000NEX going into a 2011 Jeep Wrangler with factory amp via a Maestro harness. Double and triple checked all the wiring. At first, backup camera was working as intended, however after a day with the unit, it no longer comes on when in reverse. It still comes on if I go into 'camera mode', however. I checked the config menu, and reverse always says 'low', it never switches to 'high' Double checked the wiring, no luck. Pulled out the Maestro and reflashed it, no luck Bypassed the Maestro, by wiring the 8000NEX purple wire straigh