Zeeman28a

Actually, it did. My workbench is right under a window, so I was able to expose the antenna. Sure enough, the time and date was updated witihn a couple of minutes. Thanks for the fix suggestion. It's installed in my car now and working great.

On the 8100, I have to hols down the SRC button on the remote control for a couple of seconds to turn it off. Then I press the Mode button to blank the screen. Maybe it's the same on the 7100?

Oh FFS, that didn't even occur to me. Would have been nice if they mentioned that in the manual. Thanks 493008. I've got the 8100 setup on my workbench right now and the GPS wasn't plugged in. I wanted to learn it before putting it into the car. I'll try plugging in the antenna later today to try that out. Z.

I just bought the 8100NEX and the first thing I did was upgrade the firmware from v1.01 to v1.03. (15MY_FW-Update_v1.03_16G_20150318.zip) I used a SanDisk Ultra 64GB microSD card with the SD Adapter, formatted as FAT32. I made the mistake the first time of extracting all the files/folders and put them into the root of the sd card. Can't do that. The files/folders have to reside in the AVIC5100NEX folder on the SD card. But it took about 5 minutes to upgrade, and was successful.

Just purchased the Pioneer AVIC-8100NEX and I'm going thru the setup and cannot figure out how to set the clock. The only reference I am able to find is how to set the display format of the clock. This is from the Pioneer Manual. I've even gone through all the NEX manuals for all the different models, and it's the same instructions as I posted. Instructions on how to change the display format, but nothing about how to change the date and time itself. So either I'm blind and keep missing the section on how to set the time and date, or Pioneer doesn't have those instructions. And AFAIK,