Jump to content
AVIC411.com

panabrite

Members
  • Content Count

    6
  • Joined

  • Last visited

About panabrite

  • Rank

  1. Retailer where I purchased the harness says the gmos 100 and pioneer have hard time to work together. They say just disconnect the vss and it will cure the problem :? Has anyone else run there avic with the vss disconnected?
  2. I was wondering if anyone is having a similar problem. I installed a gmos 100 wiring harness in my 08 sierra,it has all the connections vss, backup signal,sw controls. As soon as I hooked it up and reset my Z2 and calibrations it works perfect except when I come to a stop,it will always move ahead of stop..Which will cause the avic to recalculate a new route.. I thought it was the Avic that was the problem. Turns out its not because I installed another Avic Z2 I had in my VW that worked perfect and it is doing the same thing. It calculates perfect except when you come to a stop, if I move
  3. I just bought a second hand avic z2 and it has the version 3 update with 60 gig hd upgrade..It works great except it over shoots intersections when you come to a stop,so the unit will recalibrate a new route if it needs to, Not good if you don't no where you are..The unit works perfect other than that..I updated to version 5 and same deal. I have reset all the calibrations and have speed input, but seems to be all over.. Its installed in an 08 sierra. Has anyone else run into this? Also I pull into the court and by the time I am parked I am in the park behind my house..How long does it take to
  4. I did use part of the harness to power up the unit ,but the function of the acc wire from the module is defective .I phoned the manufacture and did a few trial and error tests and we came to the conclusion the harness is defective . I temporally hooked up the radio acc wire to the 12 constant with a switch in line to kill the power to the unit so it doesn't drain the battery . I am ordering a different harness this time with the vss and backup wire also in the harness .I think Pac makes it . I am relieved the unit works perfect . Very impressed with it ... Its funny tha
  5. No fuses gone. I even plugged the oem back in and it works
  6. I just purchased z2 ,I used the metra XSVI-9003 harness .Installed in my 07 passat and no go ,Nothing .I put it on the bench and did a direct connection to test and it powers up.Could it be a defective wiring harness? I have doubled checked my connections .This is the harness with the module in the harness Any input Thanks
×
×
  • Create New...