Jump to content
AVIC411.com

Someguy

Members
  • Content Count

    15
  • Joined

  • Last visited

About Someguy

  • Rank

  1. Installed an X950bt the other day. Used an Axxess CHTO-013 harness for install into a 2006 Grand Cherokee. Every time I start the vehicle, it boots up from where it left off, but then suddenly lowers volume to minimum on its own and changes modes. For example, starts on FM1, then cuts volume and switches to FM2. I've only saw it happen with basic radio so far. Still don't have my Sirius antenna or iPod cable installed yet to see if it does the same sort of thing on those source modes.
  2. actually, i replaced the garbage NAV that came with the truck. it is absolutely horrible. after some more searching, i was able to find which harness's i needed. the install was actually not bad at all. the only problem i had, was finding the illumination wire. i still am not sure which wire it is. so i left it unhooked for now. its actually not that bad at night. so im in no rush to trace it down. but if someone has the info, it would be appreciated.
  3. Your best bet is to get an z1 for cheap and upgrade it to z3 with a pre-loaded z3 drive ready, or unlock it and update it your self. even the Z1's seem to be asking a pretty penny. ill just have to keep my eyes on ebay.
  4. thats got a worse problem, than the one i need to replace.
  5. well my Z2 is screwed. i have to send it in for a repair estimate. does anyone know where i could find a Z with no wiring or harness's with it for cheap?? i dont wanna have to drive around with no headunit in my truck for a month, while i wait for mine to get repaired.
  6. another problem i have with this unit. is that it doesnt seem to follow me properly. i tried to use the nav one day. and it showed me a whole province off to the east. i attempted to use the "modify current location" option in the settings. i tried this multiple times. but after travelling for awhile. my position would be inccorect. is there a way i can reset it. so it will reposition itself with the sattelite?? i have the 2-wire by-pass done, if that matters.
  7. just tap it off the cig. lighter. it is an ignition switched 12v+ source.
  8. i posted awhile ago, about my Z2 not recognizing my I-pod. my wiring was all good. and then i also went ahead and installed my sirius tuner. got the sirius activated. and it all looks fine on the headunit displays. but there is no sound. should i just contact pioneer about this?? it sounds to me, like the problem is internal.
  9. so im going to be hooking up both a sirius tuner, and an ipod interface to the ip-bus. there is power hook up on the ipod interface, and then more power hook up on the sirius module. can i just wire up one or the other?? they have to be ponied together. so i figure if one ip-bus cable has power, than the other must too.
  10. try looking at www.pac-audio.com they carry all kinds of harness' for that type of thing. EDIT i just checked. and it looks like you need the SWI-PS
  11. i got the ipod kit for my Z2. but the unit doesnt seem to recognize that the ipod is plugged in. the ipod icon, just doesnt light up at all. is there something special i need to do??
  12. I have a Z2. and i planned on using the Ipod interface, as well as hooking up sirius radio. they both connect via an IPbus connection. but there is only 1 ipbus connect on the back of the Z2. so how do i go about hooking up both?? thanks
  13. apparently im a tad retarded tonight. i found the blue/white wire. it was on a different harness. but i just realized im going to need 2 remote wires. one for the factory speaker amplifier. and one for my aftermarket amp that will run my subs. so i should be fine to just splice another wire off the blue/white. so i can run the second take off, back to my aftermarket amp, right??
  14. i have a Z2. im installing it in a 2007 tundra with JBL NAV. i am splicing into a scosche harness. after reading through the installation manual, it seems like they are saying the blue/white wire is for the amp remote source. but there is no blue/white wire. can somebody help me out?? thanks
  15. is there somewhere i can get cutom install instructions for an 07 toyota tundra?? it is a little more involved than a normal install, since you have steering wheel controls, and it needs a harness for maintaining the JBL system. as well, i would like to know how i go about retaining my factory rear view camera. thanks,
×
×
  • Create New...