Jump to content
AVIC411.com

wrx2020

Members
  • Content Count

    2
  • Joined

  • Last visited

About wrx2020

  • Rank

Contact Methods

  • MSN
    rawkster@hotmail.com

Profile Information

  • Interests
    Subarus
  1. thanks for the response, its a wired camera with built in reverse lamps..so there are 2 wires for the reverse lamps which i wired right up to the old reverse lamp i replaced, so those lights work just fine, the video cable is connected to the BROWN out that said rear camera..so i think thats good, and as for the power to the camera is hooked up to the brown/yellow wire at the back reverse light and i have grounded it to a separate ground..so that sounds good as well, BUT i thought of something this morning, there is apparently a violent/white wire for 'reverse gear' in the pioneer harness, and
  2. Hey gang, i installed a back up camera in my x940bt (subaru sti stock). All the wiring and connections are good HOWEVER, the camera ONLY goes on during 'startup' or right when i turn the ignition on...its a blank screen (the splash screen doesn't come on) and when i go into the reverse the camera feed shows..anyways, after startup..and i press 'ok' and 'mode' the unit to normal display (audio visual map etc) the camera will no longer come on when i put the car in reverse, or won't come on at all..unless i turn off the car and start again for which it shows camera for startup only... whats the
×
×
  • Create New...