dlk

ebay - don't know if you can jump over previous updates though

I just went from 2.03 to 5.0. What features didn't you get by skipping over 3.0 - 4.6? I've noticed I don't have Pandora or aha icons, but maybe you have to be connected before they appear.

VBlue42 - If the sensor status says "ON" how can it be bad? If it weren't connected I don't believe it would detect anything unless I'm missing something about what the the sensor is looking for.

Sensor status says it's "ON".

Thanks dawgbone. I've seen that, but it says for Z110 only. I hope'd they had incorporated that in this new version but doesn't look like it.

Just completed bypass & everything works fine, but there's always this warning on bootup about the PB wire not being connected properly. This warning appears before putting the car in gear. Not sure how it determines this fault because I could actually have the PB set at this point. PB status under SetUp/Nav is "ON".

After install on AVIC-Z120BT was having reception problems. Very little signal strength. No signal displayed, SEEK woundn't find any channels, no AM reception not even noise. Checked for good ground, antenna connection, etc. to no avail. Decided to plug radio directly into car antenna without the extension provided with the radio. Voila, full signal strength, SEEK works as expected, Am stations found. Don't know if it hepls Anaolg/Digital swaping as described elsewhere here, no HD stations here, but it doesn't improve quality of analog stations which IMHO is substandard, especially compaired t

Not much more!! After installing the new & improved ?? gexp20hd this weekend on my AVIC-Z120BT, I found that the signal level was so low( nothing on the signal indicator) that SEEK couldn't find any channels - had to tune by hand - & then the station would fade out & I'm in town, not 5 miles from the tower. Am was so bad there wasn't any AM static. Also, found all other things mentioned above. Not even RDS that's on the HU & most any FM radio. Oh, the one line text display on the 120 sucks too! I did find if you plug the antenna directly into the HD radio the receptio