kerrys914
Members-
Content Count
63 -
Joined
-
Last visited
About kerrys914
-
Rank
Member
-
Funny it is the DOG barking..
-
I made a bad choice and added a sound to a POI. Now I can't get ride of this sound.. Any thoughts?
-
I did an install of the D1 in my '02 A4. Just ask if you have any Q's
-
Z2 Please help Asking for someone creative to make a Audi BG
kerrys914 replied to SHOOTER's topic in Custom Backgrounds
Will the "right click" and save work on these or do I need the file emailed to me to get the correct resolution? any more AUDI backgrounds out there? Cheers -
Anyone seen or used the new disc's yet?
-
They are to only charge you $70'ish if they only looked at the unit. If they worked on it then they charge you $200 +. If they didn't fix it then they SHOULD take it back and fix it again for free (well just shipping charges). I found that the OH office was nicer to deal with the CA. Cheers
-
They are to only charge you $70'ish if they only looked at the unit. If they worked on it then they charge you $200 +. If they didn't fix it then they SHOULD take it back and fix it again for free (well just shipping charges). I found that the OH office was nicer to deal with the CA. Cheers
-
No you will not get a new unit, as they will say you hooked it up wrong and caused the issue and it's an old device (2 levels old) I am quite sure this time they will tell you it will cost $250 minimum to fix the problem with the trans-diode relay chip. If you want us to fix it you must pay us in advance. Most people will run way with the chance of $250+ to fix a AVIC D1.. Are they charging you $70 per visit now? I had my D1 looked at for $70 in the Ohio facility, came back working fine. Cheers and best of luck
-
That's incorrect There are at least two confirmed cases that after "unlocking" the unit the display face worked again. Maybe we are talking about two different things but the post I made fixed mine and another guys D1 My D1 face would not open..pressed the buttons "unlocked" it and it worked. Cheers
-
Do a search I have posted before about the fix. There is no need to send it to Pioneer until you have done the self help check. There is a mode that locks out the screen to protect the installed disc. A few presses of some buttons ain the correct order will unlock the screen.
-
Which XM Hardware?
kerrys914 replied to ctdhokie's topic in XM/Sirius/HD Radio and Traffic Receivers
Just to keep this going How about for a D1? -
Need some help with a pre-owned Avic D2 Please!
kerrys914 replied to JiveMasterT's topic in Problems/Troubleshooting
Yellow wire has a noise filter on it. I tried to run mine without it and it SUCKED. Lots of whine and no cheese for me. Dropped the $45 on a new harness and the noise is gone and everything works fine. Used the old harness for bypass parts -
Press and hold the AV and INFO buttons at the same time AS you reset the unit. I am 99% sure that is how you unlock it, worked on mine this past weekend
-
how high should the speed pulse signal go?
kerrys914 replied to bryancx94's topic in Problems/Troubleshooting
On an '02 Audi it looks like reading is 1/100 motor RPM. -
I have an 2002 A4 B6 and if they are the same I can help you out. - ACC 12+ needs to come from the fuse panel, nothing behind the Bose for that. - Ill. needs to come from behind the light switch - VSS is bl/whte wire located in the green connector behind the cluster (just about behind fuel gauge). Best of luck