Good evening all,

I have searched this forum over to avoid asking a question that was already available. I have a Z2 that has no open spots for moving a pin so I can ground and do the bi pass. My unit even has the newest software straight from pioneer. Manufacture date is Nov 07 and I have already grounded the e-brake wire. The pin position that should normally be grounded with Super Hippocrite's directions is actually my front left speaker positive wire. Just to be safe I have looked a dozen times and there are no pin positions available to ground. Any ideas on which wire I may be able to ground?

TIA

Jim

That's not AV connector 2 - you're looking at the power/speaker connector.

You need Harness #2......Not the power harness.

I ran into this as well when I first installed mine. My unit shipped with two RCA harnesses, but the second one was the incorrect one. In fact, I still don't know what that thing is for. I bought the correct one on e-bay and then I thought to contact the seller I got the Z1 from and they sent me the correct one as well...so I ended up with two #2 harnesses.

If you still need it, I have it. Send me a PM.