Not sure whether to post in troubleshooting or vehicle wiring, so here it goes. Just had a D2 installed in a brand new 2006 Honda Pilot EX-L. Looks fantastic.

I'm pretty sure they messed up the parking brake wire (I get a warning when turning on the vehicle) and the VSS wire. Is the VSS wire supposed to give the speed pulse? Can anyone provide info on my vehicle for this?

I'd like to pull the unit out a bit and take a look. This is the first aftermarket system I have not installed myself, and I'm just not satisfied with it not being 100%.

Here ya go all the wiring you should need.

Reverse Light green/black + passenger kick, harness to rear

Parking Brake green/red or green/purple - driver multiplex ctrl unit, pin 15
Notes: The driver multiplex control unit is attached to the driver side fuse box. It has a green 22 pin plug on the side of the fuse box facing the firewall.

Speed Sense blue/white ac driver multiplex ctrl unit, pin 14
Notes: The driver multiplex control unit is attached to the driver side fuse box. It has a green 22 pin plug on the side of the fuse box facing the firewall.

Thank you!! Do you know if it's also possible to integrate the steering wheel volume controls for the Pilot with the D2?

Yup just need an interface availible from www.pac-audio.com

Is the wiring the same for an '03 Pilot EX?

I'm moving my AVIC-N1 from my '98 CR-V into my "new" '03 Pilot and I don't have the service manual yet to find the wires myself.

Thanks!

hondapilot.org is another great site for your car's info w/ pictures.

03 honduh Pilot

Speed Sense blue/white cruise control actuator
Notes: The cruise control actuator is behind the passenger side headlight.

Reverse Light green/black + passenger kick, harness to rear

merry xmas