I have searched high and low, but have not been able to find a definative answer to a solution to the software bypass after the "genuine" 3.0 Pioneer update.Could someone post a guide (or a link to an existing guide) that goes thru the steps required for a successful software bypass once the 3.0 update is complete, and if it is possible (with the "genuine" Pioneer update)?

I have the Pioneer Avic F90BT btw...

I had everything working (bypass wise) when I had the 2.* version. I have the parking brake wire grounded, and had made mod's to the files, and could watch video & input addresses on the go.

Once the update was complete, I now get messages that my ground is "improper" and some other annoying message, but once I get over 2mph, the video goes, as does the input of addresses

This would be a great "sticky", and again my apologies if this has been covered, but not for lack of trying! I have searched high and low, but may have not searched with the correct keywords.

Thanks in advance for your help!

Charlie

Its the same as what you had before. Just go in and change the file again and you should be good to go. Details if you don't remember are in the F series FAQ.