I have had my x920bt installed in 2 different cars with the same issue. After 30-40 minutes of driving

with my iphone connected to the cable and listening to Pandora or my ipod, the stereo looses communication

with the iphone. It will not reconnect until the car has sat for a while, which leads me to believe it is a

heat issue. It will still stream via bluetooth and the sound still works, but the phone won't connect via

the cable. I have tried two different iphones with different firmware versions with no change. I have also

tried to duplicate the problem with just power and ground connected on the bench (no outputs connected) and

my iphone was still communicating fine after 3 hours. I sent the 920 back to Pioneer to be repaired, and they

sent it back to me with no explanation if repairs were made or not. Just a receipt that says, "no charge,

under warranty." They didn't even send my original box back. While waiting for the 920 to come back, I traded

vehicles, and after installing the 920 in my new car, I have the exact same issue. I have searched and not

found this issue mentioned elsewhere, so if anyone has any ideas, I would appreciate it.

Replace the iPod cable and see what happens.

That's just about the last thing I have to try. My dealer is sending me one this week. I will be suprised if that fixes it though. Mine works well and plays video fine too, until it gets hot. Since the cable doesn't contain any electronic components like the hu, I wouldn't think heat would affect it unless it was pretty extreme. Thanks for the reply though. I'll let you know what happens with the new cable.

Finally got the new cable. It appears that was the problem. I drove about an hour and a half listening to

music on my iphone yesterday with no problem. However, when I tried watching a video, it wouldn't work. Then

I remembered I just upgraded my iphone to 4.3.3 so I tried my wifes iphone which is on 4.0 and the videos

play fine. I guess the x920bt firmware won't support 4.3.3 video?

Glad it is working.

I have no problems running video from iPhone with 4.3.3 to the X920BT.

your right that there is no electronics in the cable, but there is electricity flowing through the wires, all wires have resistance, resistance causes heat, the heat could have made a weak connection go in and out.