anyboby know were to hook up the illumination wire on a 2006 ford

explorer with auto lamps, also hocked up my vss wire to the same wire ford uses for the speed senstitive volume on the original radio and it

is not sending a signal to my z2.. thanks in advance

Radio Ignition green/white + radio harness

Speed Sense purple/orange PCM, 50 pin plug, pin 1

The PCM (Powertrain Control Module) is on the passenger side firewall.

The VSS wire is also found at the windshield wiper motor, pin 4.

misfit, thanks for the prompt reply, will the green and white wire ,

signal the z2 into day or night mode when the auto lamps are set,

thanks in advance

it should, if it doesnt use yellow/gray parking light wire in kick panel