pgn29

A simple this to check is make sure the harness with your speaker connections is completely installed in the back of the Z. I assume you had to remove the head unit to replace the touch screen...

Thanks much for your response. Yes I checked all the connections. In fact I have all my speakers running off the HU and just the subs off of the preamp RCA sub output. I tried the blue wire trick lat night and even resetting the unit per the manufacturer suggestions (three different methods). Still nada.

I tried to email ducatiboy but his email is full. He is surely in demand.

thanks again!

Hello all,

Well my screen I have had my Avic Z1 working fine for over three years (have 2 wire bypass as well). About 2 weeks ago my touch panel screen cracked (not the LCD. I sucessfully replaced the touch panel and all works well. The problem that I have now is no sound from any source. If I turn the volume up all the way I get the subs to rumble. My speakers are connected directly to the HU, and my subs are connected thru the RCA sub outs into its own Amp.

I did read on another site that the Antenna settings on the radio could cause no audio (but I toggled it from Power to Radio) and still no dound at all.

Any ideas. Is there something internal to the radio (fuse perhaps) that I can fix. I traced all fuses in the car on HU and nada.

Please help, and thanks much!

Soory Gents for the newbie questions but I have been out of touch for a while. I have a Z2 and the last update I did was last year 2008. What and how do I sucessfully update my Z2 to Z3? Step by Step would be greatly appreciated.

Thanks,

PGN

Gents,

I have had my Z2 in my car for a year. I took it out b/c I was having a heated seat issue in my 07 350z, and the dealer was questioning the radio as an excuse. I took it out to avoid that issue.

Now, I put everything back together, and my GPS is way off, no directional voice guidance except (you have arrived). Any ideas? I am wondering if I damaged the sensor/wiring. Also, in the 3D calibration screen it says "sensor initializing" but stays on that setting. I am sure that it is stuck or something.

Also, I just wanted to say thanks to all of the mindshare in this forum. You guys are the best!

Please help,

PGN29

I have a Z2 which is sucessfullt bypassed. I told my cousin to buy a Z2 and ship it to me. I wanted to remove the hard drive from that new unit, stick it in my Z2, and run the ISO updates on it to bypass the drive. Is that possible?

I have a Z2 which is sucessfullt bypassed. I told my cousin to buy a Z2 and ship it to me. I wanted to remove the hard drive from that new unit, stick it in my Z2, and run the ISO updates on it to bypass the drive. Is that possible?