xray328

My next step is to power the camera directly off the harness.  But like I said, I can’t use the current one that way because the lights will be on all the time.  

First video is our problem as described above.  Second video shows an occasional glimmer of hope.  I’ve tried two of the same cameras, same issue.

It does.  Everything’s working but I can’t get an image on that particular input.  Could I have a bad RCA plug on the receiver?  

Hey guys.  I'm pulling my hair out trying to figure out why my backup camera isn't working.  When I shift into reverse the stereo switches to the backup screen but the image is black.  I have the camera's rca plug plugged into the brown backup camera input.  When I take that same rca plug and plug into the AV input the camera works fine, but again nothing when I plug it into the brown camera input.Both the turn on wire and the camera's power are tapped into the positive reverse light.  In troubleshooting this I even went so far as to ground it to the harness (after trying the chassis to eliminate ground as an issue.) It seems that the camera's working with the AV input so I don't think the camera's the issue.  I have verified the camera input is on in the settings.  I can't wire the camera to a switched source because it has bright LED's that would be on the entire time.

The pictures below show the camera working when on the AV source, but as you can see there no image when connected to the brown rear camera source 

Any ideas?