Lancer28
-
Content Count
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Posts posted by Lancer28
-
-
XM only charged me a small fee to switch radio id. All else remained the same.
If there is a reset button on your xm adapter press that along with the reset button on the 910 when every thing is hooked up and powered up.
I did not think the XM module to be all that big. The bus cable was long enough to put the module in the trunk.
Good luck
-
That was a Knarley, Knurley Knob you sent me. Just knob to do the job.
-
From the repair manual for the F900BT. I think the X910BT is the same size.
Chassis 7 inches X 3 and 7/8 inches X 6 and 1/2 inches
Nose 6 and 3/4 inches X 3 and 7/8 inches X 3/8 inches
-
I believe this signal comes from your regular AM / FM antenna. Be sure it is connected. If you have the HD radio you will need to get a antenna splitter to go to both the HD module and the back of the radio. Also if your car has an antenna amp, be sure it is getting power.
-
The auto timezone setting does not work correctly for me. I am the EST zone and the unit insists that it is CST. I can manualy set the timezone and time but the time calculations are still off by one hour.
I have tried another unit with the same results.
Any suggestions?
-
I am having the same problem with no station id in the presets.
Auto Time Zone
in Problems/Troubleshooting
Posted
Update.
For some reason the auto time zone does not work correctly in East TN. I have traveled N to S into NC and the unit will show correct timezone after crossing the state line. When going S to N back into TN it changes to the wrong timezone again. It just does not like EST in East TN.