Jump to content
AVIC411.com

Search the Community

Showing results for tags 'hard reset'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Announcements
    • Welcome/Site News
    • Custom Backgrounds
  • Pioneer AVIC Navigation Units
    • NEX Series
    • Z Series
    • X Series
    • F Series
    • D Series
    • N Series
    • AppRadio, AppRadio 2, AppRadio 3
    • AVIC-U310BT
  • System Add-Ons
    • General
    • XM/Sirius/HD Radio and Traffic Receivers
  • Other Discussions
    • Off-Topic
    • Vehicle Specific Wiring
    • Security/Stolen AVIC's
    • Classifieds (Buy/Sell/Services)
    • Archive

Blogs

  • Official AVIC411 Blog
  • Popular Topics
  • gadgeeets' Blog
  • Gmane's Blog
  • joirico27's Blog
  • Double's Blog
  • trailer's Blog
  • pimpcee1981's Blog
  • kodunmit's Blog
  • moses' Blog
  • bharper351's Blog
  • cjmccarthy12's Blog
  • jimbocorvette's Blog
  • ayother's Blog
  • Tluda
  • sandjieuw's Blog
  • TI 3VOM's Blog
  • imgizzy's Blog
  • avic 910bt bluetooth issue
  • riderdog's Blog
  • riderdog's Blog
  • avalanchegroup's Blog
  • avalanchegroup's Blog
  • AVIC X930BT
  • jacks1872001's Blog
  • Ashante503's Blog
  • manugude's Blog
  • Vollgatter's Blog
  • poisidon33298's Blog
  • raincitydj's Blog
  • jadamache's Blog

Found 2 results

  1. My screen calibration is messed up. I cannot even enter my password. It won't let me go to the number screen or any of the system settings the only screen I can see is the password screen I need help with factory reset or hard reset using front buttons or any other possibilities. Please help.
  2. I attempted to update my nav software on my avic z140bh. I followed the instructions to a tee up to the point where i had to select "System uCom Write" i inadvertently pressed System uCom all Write. When i attempted to stop this it continued to write. Eventually i got an error message. I tried to remove sd but was unable to open screen. I removed battery cable and then reconnected but to no avail. Then the unit went black. I have not been able to revive it. I just checked fuse at rear of unit; it is o.k. Any and all suggestions welcome re: unbricking or removal of sd card. Thanks
×