London Dub Posted September 27, 2006 Report Share Posted September 27, 2006 Hi everyone, I searched for this info but only found it for the Z1.... I bought my D2 used, and I want to make sure I have all the pins correct. I know that there is supposed to be a blank pin....but I think that MY blank pin should actually be the ACC wire, and the bypass hack has already been done. Can someone post the pin diagram for me so I know how I should set up my harness? Also, on my line for the battery hookup, it has two black wires coming out of the little black box (I don't remember what it is)......the manual shows only one, coming off the side with the fuse. I know this is to ground, but the other black wire (off the opposite side) goes into teh wiring harness next to the main ground. Is this normal? Quote Link to post Share on other sites
London Dub Posted September 27, 2006 Author Report Share Posted September 27, 2006 The D1 harness is the same... so if anyone could help me out here.... Quote Link to post Share on other sites
cntrylvr79 Posted September 27, 2006 Report Share Posted September 27, 2006 Look for my response in the following post. [url=http://avic411.com/forum/viewtopic.php?t=1570&start=0&postdays=0&postorder=asc&highlight=]http://avic411.com/forum/viewtopic.php? ... highlight=[/url] Quote Link to post Share on other sites
London Dub Posted September 28, 2006 Author Report Share Posted September 28, 2006 ^^^ Thank you - I found your post.....but then lost it.....and I couldn't find it again.... Turns out the bypass has been done - so I just need to get a new AVV wire - score! Thanks, BTW - this forum has been a big help - I'm sure I will frequesnt it often. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.