greydragon Posted September 7, 2009 Report Share Posted September 7, 2009 Hello, I have an F90BT and after I updated the unit with new 3.0 from pioneer, it will boot into the destination Tab? I'm not sure why, and it doesn't allways do it. Install went flawlessly. Has anyone run into this issue, is their a fix or hack that I can perhaps use to fix the situation. I know how to use test mode and swap files but don't like to do it without some direction. Does anyone have a sugestion on what file I may have to replace? Thanks for any help you guys may have. Quote Link to post Share on other sites
phoenix Posted September 10, 2009 Report Share Posted September 10, 2009 I have the same problem intermittently. No solution at this point. After I shut down and restart it is usually OK. Really a PITA though. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.