gatorboy Posted December 31, 2009 Report Share Posted December 31, 2009 Just upgraded from a d1 to the z110bt. I had a ND-BC2 back up camera hooked up to the d1 and it worked great. The installer then switched out the units and hooked the bc2 up to the z110. during the day the camera looks great, although if you look closely it looks like there are some static lines in the picture. AT night these lines become much more pronounced, kind of looks like a tv when the bunny ears arent getting a great signal. Tonight a car back out behind me and when the lights hit the camera the lines seemed to go away. I asked the isntaller about this and he couldn't seem to figure it out, becasue he said all he did was unplug it from the d1 and plug it into the z110. Any ideas? Quote Link to post Share on other sites
aleicgrant Posted December 31, 2009 Report Share Posted December 31, 2009 have the same camera with no issues. May want to check for interference somewhere? Quote Link to post Share on other sites
gatorboy Posted December 31, 2009 Author Report Share Posted December 31, 2009 The only thing I could think of is if the cable runs to close to a power wire, but I can't think of where that would be different from before. Plus, my installer didn't seem to think that would matter to much. I know the camera is fine becuase it worked on the d1. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.