Willian Ricardo da Silva Posted December 16, 2011 Report Share Posted December 16, 2011 Hello, friends need a help of you. I have a x910bt and installed a reverse camera, however I can only see her when I go to the option "camera back." I wonder how can I get the picture appear automatically when I engage reverse gear. Please I need help thank you Quote Link to post Share on other sites
1loudls Posted December 20, 2011 Report Share Posted December 20, 2011 cut and pasted from another thread: ok so this is going to be very simple, A: make sure that the option is turned on in the menu B: make sure the polarity setting is right (negative for negative trigger reverse wire, and positive for positive trigger reverse wire) C: verify that the wire is getting the correct signal with a DMM as close to the avic as possible if the settings are correct, and the wire is getting the correct trigger and it is still not working, something in the unit is broke. if the reverse wire was shorted out, and it was a positive wire, there could be a blown fuse or damage to one of the cars systems, and the signal isnt being sent. Quote Link to post Share on other sites
Willian Ricardo da Silva Posted December 22, 2011 Author Report Share Posted December 22, 2011 The link is correct, I wonder where in the active menu or disable this option, because it can only be that. thank you Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.