Avic-x920bt wiring question in 07 dodge ram

[Sjs67]

My truck has the infinity non nav system. I'm installing Avic-x920bt. The wiring is a bit confusing...now mine has the factory amp so from what I read on the PAC c2r chy4 is this correct?

 

I found this on another post....is this correct? So you take the front outputs from the pioneer deck and wire them to the rear of the PAC harness? So how will the front speakers get sound?

 

Description for PAC * PAC C2R-CHY4 * AVIC-920BT * Description for AVIC

Battery +12V (2 of these) * Yellow * Yellow * to always on power

Front L- * White/Black * Green/Black * Rear L-

Front L+ * White * Green * Rear L+

Front R- * Grey/Black * Violet/Black * Rear R-

Front R+ * Grey * Violet * Rear R+

Ground (2 of these) * Black * Black * Ground to metal body

Antenna On Input (NU) * Blue * *

Accessory Output * Red * Red * To Electirical terminal controlled by ignition switch

PB Output * Red/white * Light Green * Parking Brake

VSS Output * purple/white * pink * Car Speed Signal Input

Illum Output * Orange/white * Orange/White * to lighting switch terminal

Reverse Output * Green * Violet/White * Reverse Gear Signal Input

SWC Output (on 11 pin) * white/green * *

Amp Turn on Input * Blue / White * Blue/White * Auto Antenna Relay control

Rear L- * Green/Black(NU) * *

Rear L+ * Green (NU) * *

Rear R- * Purple/Black(NU)* *

Rear R+ * Purple (NU) * *

* * White/Black (NU) * Front L-

* * White (NU) * Front L+

* * Grey/Black (NU) * Front R-

* * Grey (NU) * Front R+

 

 

Thanks in advance

 

[1loudls]

i have never used a PAC module for factory amp integration, however with all the metra modules Ive used, you just hook it up color to color like normal (except for P-brake, reverse, and VSS, those colors are usually a little different)

[ppennza]

i know this is late but i have a ram. You might have figured this out but you have to reverse to of the wire it says it in the instructions i think it gray and purple or green and purple or the sound wont work