mobilesolutionsca Posted August 4, 2013 Report Share Posted August 4, 2013 I installed a z150 into a truck about two months ago and it seemed to work fine for about two weeks then I started having problems. Original install was moving the mute wire over and grounding it along with the pb wire. After two weeks it stopped working when driving, today I pulled it apart and everything was connected correctly but I have had different people say the bypass is different ways so I tried them all. Cut vss and grounded mute and pb and it works but a message on the nav comes up saying no speed sense detected will start callibration. reconnected vss and ground mute and cut pb, this only works when stopped. each time I have disconnected power and reset radio anyone seen this? will the message go away for the calibration? I drove the car almost 50 miles and it never shut off HELP!!!!!! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.