Lancer28

Update. For some reason the auto time zone does not work correctly in East TN. I have traveled N to S into NC and the unit will show correct timezone after crossing the state line. When going S to N back into TN it changes to the wrong timezone again. It just does not like EST in East TN.

XM only charged me a small fee to switch radio id. All else remained the same. If there is a reset button on your xm adapter press that along with the reset button on the 910 when every thing is hooked up and powered up. I did not think the XM module to be all that big. The bus cable was long enough to put the module in the trunk. Good luck

That was a Knarley, Knurley Knob you sent me. Just knob to do the job.

From the repair manual for the F900BT. I think the X910BT is the same size. Chassis 7 inches X 3 and 7/8 inches X 6 and 1/2 inches Nose 6 and 3/4 inches X 3 and 7/8 inches X 3/8 inches

I believe this signal comes from your regular AM / FM antenna. Be sure it is connected. If you have the HD radio you will need to get a antenna splitter to go to both the HD module and the back of the radio. Also if your car has an antenna amp, be sure it is getting power.

The auto timezone setting does not work correctly for me. I am the EST zone and the unit insists that it is CST. I can manualy set the timezone and time but the time calculations are still off by one hour. I have tried another unit with the same results. Any suggestions?

I am having the same problem with no station id in the presets.