-
Content Count
7 -
Joined
-
Last visited
About kbrandsma
-
Rank
Recent Profile Visitors
1,001 profile views
-
No Applicable Programs and No PRG0 and PGR1 folders - Help
kbrandsma replied to kbrandsma's topic in Problems/Troubleshooting
Got it. Thanks a lot, I will give it a try! KBRANDSMA- 14 replies
-
No Applicable Programs and No PRG0 and PGR1 folders - Help
kbrandsma replied to kbrandsma's topic in Problems/Troubleshooting
Went to paste PRG0 and PRG1 to the HU Users directory and the previous failed firmware update created a PRG1 folder and placed several files and directories in it. I pasted the directory PRG0 and re-ran the update and again got the same install error message. Should I try creating other directories that I am missing on the root directory? Where can I get a list of directories that should be on the X140BH? Thanks in advance, I really appreciate your help. KBrandsma- 14 replies
-
No Applicable Programs and No PRG0 and PGR1 folders - Help
kbrandsma replied to kbrandsma's topic in Problems/Troubleshooting
I tried doing the Firmware update and got an error message and then the installation stopped and exited the install process. See below? Any help? http://youtu.be/8KSFI9MEnfE- 14 replies
-
No Applicable Programs and No PRG0 and PGR1 folders - Help
kbrandsma replied to kbrandsma's topic in Problems/Troubleshooting
The HU is stock and very vanilla, no hacks whatsoever. I've tried the hard reset and left the battery disconnected over night at least a couple of times. Any suggestions would be appreciated.- 14 replies
-
No Applicable Programs and No PRG0 and PGR1 folders - Help
kbrandsma replied to kbrandsma's topic in Problems/Troubleshooting
Or by updating the firmware cause damage that can't be undone? Anyone?- 14 replies
-
No Applicable Programs and No PRG0 and PGR1 folders - Help
kbrandsma replied to kbrandsma's topic in Problems/Troubleshooting
Would updating the firmware take care of the missing PRG0 and PRG1 folders and the files inside them?- 14 replies
-
Hello, I'm new to the forum as a registered member but have used the site before and have been appreciative of the great stuff here. I recently swapped out my battery and on reinstallation my AVIC-Z140BH showed my custom Splash Screen and then immediately displays "No Applicable Program". I downloaded testmode on a SD Card and was able to check the USER Directory and there was no PRG0 or PRG1 subfolder. How do I reinstall these files? Thanks in advance? KBrandsma Here is the error message Here is the Root Directrory of My AVIC Here is the USER s
- 14 replies