petku

Sorry for late reply, I will try something else.

Hello guzimo, thank you very much again ! Now it speak czech. But when I change car icon on map, system restart and not working. Restart not solve this problem. Only erase and copy whole My flash disc in test mode. Any idea ?

Looking for czech voice files, that are stored in folder : My Flash Disk\APL2\iGo\Audio\CZE_F and CZE_M . Or anybody have Czech content backup ? Thank you once again.

Thank you very much for all your support. After few hour today I get it to working condition with new maps .

Finally I bought another stucked AVIC-F700BT. After WinCE update it working, but which firmware is the best for maximum performance and which maps are latest ? Found maps 2014 Q1, but I have not experiences with map update on Pioneer units. How to register new maps in the unit ? Thanks for any relevant info.

You have right. Must check ebay, maybe I will get some for parts. Thank you and regards !

Thank you for SW, but this unit is probably definitive death. Here can help only navi board exchange.

No, after yesterday uboot upgrade it wont set up to the service mode (blue screen). Any other idea ? Factory reset ? On the bottom right side of the navi board they are 2 tact switches. Anybody know, what to do with them ?

Hi guizmo, thank you for another program or solution. At this moment my AVIC is totaly death. After uboot upgrade it write uboot OK and restart itself. Now it can´t setup into service mode. I´m lost. Please need help, how to write FW into nand chip by external programmer.

Can somebody confirm or help me, how to start Condi's HACKMODE via service mode ? Or how to write firmware on-board (W/O remove chip) from PC via programmer (JTAG). Thank you and regards. Petku

Can anybody help me with UBOOT upgrade ? Found on the net UBOOT for F900, but CRC error. Please help me with correct files UBOOT.bin and UBOOT.cks . Thank you very much for your time Regards ! Petku

Hello all, I´m newbe here, but with service of electronic equipments I have lot of skills. AVIC-F700BT, which I´m trying get back to life is after amateur intervention. I exchanged damaged FPC connector on TFT board and FPC cable between TFT board and switch board. After that now I´m able switch unit to the service mode. BUT when I run WinCE update from SD, it start read from 0 to 100% and in this state it remain. Update WinCE will NOT start. Read lot of threads at this forum, but all solution without sucess. What I´m doing wrong ? Can I run test mode without previou