jesusq

I had the radio installed by someone who I am no longer in contact of. I've also been reading this forum for what to solder and pictures and I cannot find the post. Does anyone know where that post is? Or is there any pictures of how to do this?

I have the n2 and just received it back from Pioneer after the Flex cable gave up on me. When I had it installed they put a bypass switch so that I can use the navigation or watch movies while driving. I also upgrade the software from the 50mt to the 70mt right before sending it to Pioneer. Once I received it, I'm not sure if they did a firmware upgrade on the unit, but I am getting an "Improperly configuration of the brake cable" error. when I check the status of the cable, it shows Brake ON, but if I drive, it changes from Brake ON to Brake OFF and I cannot use the navigation unles

I have the n2 and just received it back from Pioneer after the Flex cable gave up on me. When I had it installed they put a bypass switch so that I can use the navigation or watch movies while driving. I also upgrade the software from the 50mt to the 70mt right before sending it to Pioneer. Once I received it, I'm not sure if they did a firmware upgrade on the unit, but I am getting an "Improperly configuration of the brake cable" error. when I check the status of the cable, it shows Brake ON, but if I drive, it changes from Brake ON to Brake OFF and I cannot use the navigation unless