Jump to content
AVIC411.com

cntrylvr79

Members
  • Content Count

    4,614
  • Joined

  • Last visited

Posts posted by cntrylvr79

  1. Change the power antenna setting from radio to source. Check the manual on how to do that. Or disconnect the blue wire of the wire harness you bought from the blue wire of the avic and reconnect it to the blue/white wire of the avic. Common problem.

     

    Pink vss wire would be connected to the blue/white wire at the cruise control module under the driver's side dash.

  2. Could just turn the gains on the amp all the way down. Then turn the volume up on the avic until you hear distortion. then back it back down until the distortion goes away. Of course this should be done with asong your very familiar with so you know when it's distorting. Oh and it's best not to use hiphop/rap as that tends to be very extreme on it's swings.

  3. It'll fit fine. The kit you need is a 95-5026. As for bypassing the amps, you can if you want to. But you don't have to. If you get a 70-5519 you can get away without bypassin the stock amps. The only thing you'll want to do is put a 2.4k ohm resistor on the amp turnon lead to prevent turn on thump.

  4. Your problem with the xm status is a common one. It depends on which tuner you have.

     

    GEX-XM10T - will say that if the data cable is bad or not connected.

    GEX-P910XM - Will always say that since it lacks the data cable required to send the information to the avic

    TERK XMD1000 & XMDPIO110 combo - Again will always say that since it lacks the data cable to send the infor to the avic.

  5. Well its been over 24hrs and i have done alot of driving and i still cant get the speedometer function to work. Any other sugestions? Thanks

     

    And how many miles is alot. If it's less than 100 then don't be surprised it's not working yet. It takes miles NOT hours of driving.

×
×
  • Create New...