Santeli

I just upgraded my z150bh to the 1.06 firmware. The upgrade completed and my unit rebooted as expected. However, when I go to check the firmware level it is still showing Ver 1.0. I attempted to rerun the upgrade nothing happens when the SD card is inserted. This happened the same way with the previous upgrade, but I did get all of the functionality of IPhone 5 support. Anyone seen this situation before?

I am attempting to use the Auto EQ with my newly installed 150BH and the pioneer microphone. I am able to select it and it starts, but after a few seconds into the process I get an error message on the screen to check the front speakers. I am not sure what that means since the speakers are fine and working. Any ideas as to what this error means?

[quote name="PaisanNYC"]hey sportsfan :) I think youre right. I believe there is an ip bus cable for xm radio, and an ip data cable for navtraffic service.[/quote] OK that makes sense, I need the two cables to make this work. In the tuner unit there is a warning not to connect ACC power (red) , I assume it gets ACC for the IP Bus cable. Thanks

I just received a GEXP10XMT as a gift and I am interested in installing this unit in the trunk and then run the wire (s) to the AVIC-Z1 already installed. I want both the XM function and the traffic updates. To make this happen how many wires need to connect back to the AVIC-Z1? In the AVIC-Z1 install manual it shows you need an extension for one of the connections, but the diagram is a bit confusing as to how many connections are actually needed, since it shows other components that I don't have. I bought one extension cable, but the second cable with a blue connector in one end is not long e