beven6

OK so i just recently purchased the z2 and have done the 2-wire bypass, i put the yellow/black wire into the empty slot and spliced it into the parking break wire then grounded it. I then burned the file as an image using both nero and alcohol 120 and i get the same response from the unit "disc update already been updated" something along those lines. I reset it and still get that message. I then drive my car and everything worked for about 5 minutes then it said that my parking break wire was not hooked up properly, so then when i drive above 18mph it would cut me off. As of right no

alright, thanks a lot guys.. got my ipod working with no issues. just one last question. I downloaded the file as a picture using nero software from a pc and put it in my car, it said the maps have already been updated so i reset it and it just said the same thing, so i drove for about 10 mins or so and the bypass was working and now it decided to stop, it brings up the same thing it did before with the improper e-brake hook up. should i try to re download the file or what?

ok so i picked up everything i need for the ipod adaptor, where do i tap the yellow wire into, the wire harness? i know i ground the black one but unsure what to do with the yellow?

well they gave me it for free, and just told me i needed to get the wires so im not really complaining. the arrow is not jumpy at all but if i ever does then i will end up tapping into the vss also early today i burned those files to a disc using nero software from a pc as an image and put it in and it took a minute and then when i clicked on maps it said the maps have already been updated, so i reset it and it worked for about 10 minutes and then locked me out again, should i try re-burning it? you guys have been very helpful.. thanks a lot!!!

ok im new to all this, and it was my first radio i have installed. where would i get the first 2 at, besides online.. radio shack?

what do you mean.. the people at best buy just gave me that black box with the ipod connecting wire that comes out of it, i have to get the other cables for it, i know i need the ip-bus cable but not sure where to get it from but do i also need the power supply cable as well?

well i went up to best buy today since my buddy use to work there and they gave me the cd-Ib100II but i need to get the ip-bus cable, which i was wondering who sells that, and do i need to use the power supply spot on it? since this is the older version for the ipod im a little confused with it. So they just gave me the black box. they also took care of my check engine light, they just cleared the code, but if it comes back up ill just take it to a dealer since its still under warranty.

i installed it in my 2006 350Z, i just went to best buy and picked up the pioneer ipod cable for pioneer that fits into the port in the back of the radio it has 3 square corners and then one curved corner which if i remember correctly.. fits into that bus port. it just doesnt want to even connect my ipod to the radio.. the cable does nothing I am going to try and move the antenna because i believe that might be the issue with it

ok so i spend the day installing the avic z2, everything went well except for the fact that the ipod cable that i had bought does not seem to read my ipod, has anyone had any issues with this or could help me out. also i did the 2-wire bypass and i get all the features now but for some reason its not reading the maps, its stuck on my current location and does not want to tell me where i am at, i did not download the files and was wondering if that could be the issue. could it be that i never spliced into the vss wire?? and one last problem is that my service engine soon light had co