STNC

I already have the big 3, as I've heard capacitors are just bandaids for a system.

Before I go ahead and do this soon, I had an idea on what else could be causing this.

 

I have a system that draws a large amount of power, often it dims my lights and such, could this be the issue? If I were just to get a bigger battery would that fix this?

kk

and which side of the resistor should I connect what too?

kk, and this should fix this? is this a common problem?

so kinda like a Y

 

the top of the y are the two ill

 

and the bottom is ground

kk, so its an issue with how much current is getting through? And I just put the resistor between the f90 ill wire and the harness ill wire?

 

And one like this:

 

http://cgi.ebay.com/5-1-4W-1000-OHM-1-OHMITE-RESISTOR-R5J1K0-NOS_W0QQitemZ370069680115QQcmdZViewItem

 

or

 

http://cgi.ebay.com/50pcs-1k-Ohm-Resistors-1-4W-5-1000-ohm-1-K-carbon_W0QQitemZ150286612634QQcmdZViewItem

bump

Hi Everyone,

 

I have an AVIC-F90BT installed in a 2007 Scion tC. I put it in around a week ago. Recently, When the headlights have been off, after about 10 or 15 minutes, the screen starts to flicker to night mode, and then back to day mode, and then back again, and it just keeps flickering. When I turn my running lights on it goes to night mode like it should, and then it stops flickering.

 

Does anyone know what could be causing this? Could this be an overheating warning?

 

Thanks!

Michael

roger, i'll get on that

Hi,

 

I just installed my F90BT, but I didn't connect the speed wire. I did the mute wire hack, and I was curious that if I connect the vss wire, will the headunit become aware and not let me watch videos anymore?

i think i have the right post bookmarked that you are talking about, I will keep you all posted on the install.

is it just orange or orange and silver?

Hi,

 

I just got my AVIC-F90BT today, I have already done the mute wire repositioning for the motion hack. I did have one question though, I have read that the Orange wire from the HVAC is the VSS wire, at least in 06 versions of the tC. Can anyone confirm if this is the same for the 2007 tC?

 

Thanks!

http://www.visualit.co.uk/PocketPC/simplesms.htm

 

This might be a solution for the WinMo people

I drive an 07 tC, what wires did you tap/wiring harness did you use?

do you think this headunit will be able to be bypassed?

Any chance either of you guys are using the D3?

They will fit, you have to sacrifice the top air vents, the other issue is the half inch thick metal that surrounds the radio, if the installer can get past that, then it will work, they almost couldn't do it with mine, but i got lucky and it all worked out, it all depends on the perseverance of you're installer.