BrianStanton

I didn't run a separate ground wire, and have 0 AM reception on my Pioneer, so I'm going to try adding one to see if that helps

When using the Connects2 adapter, should I run a separate ground wire, or can I just use the ground wire in the adapter?

Audio does mute for an incoming call, correct?

I think I've found my answer, the ISO connectors need to be cut off and wired into the navigation unit...

Is there a programming phase of the installation for the steering wheel controls on the Connects2 piece? Or does it work as they did from the factory?

I'm looking to instal a 700BT in my 08 TT w/ bose. From my research, I need this adapter (CTSAD002 from Connections2) that takes the place of all the PAC stuff, I see where the Bose stuff plugs into the RCA's, and where my harness that plugs into the factory stereo plugs into the largest connection. What do I do with the ISO connectors? And what are the 3 loose wires in with the RCA's? I think the smaller connector on the right goes to the CAN BUS, that's what the small box is, right? And then a Pioneer lead from that to the stereo remote input Thanks for any help