jambo1

duh, I'm sorry, I should have waited for the GMOS-01. The instructions on this doesn't require me to fish around for the wires I mentioned above. Instead it acts as a quick connect harness with instructions to connect to the existing factory harness that will have all the necessary wires anyway. Don't understand the jack plug on the SWI-PS though. Were does this plug into on the 900BT? On the laoction for the wired remote input? If so, then it's too small for the standard 3.5mm jack on the 900BT....thanks in advance.

One last thing. I do not have access to the car's wiring diagram. I am looking for the VSS, parking brake & rear gear wire. Thanks.

It does not say Bose anywhere. So I gather that this is the 6 speaker standard system without an amp? So I can just install the avic, and use the current wires to the current speakers (and change the speakers at any future date without opening up dash again)? Thanks so much for the help.

Thanks for the response. I am also not too sure if there is an existng amp in the car. Is there an easy way to find this out?

I am installing the 900BT for a family member and would like some help on all the things I would need. I have installed things in my Passat 08 and have access to wiring diagrams etc, but NOT for this Buick (2003 Rendezvous, 6 speaker setup with standard stereo), which is entirely new to me. So consider me a newbie here. So far I have marked the following to purchase: Avic 900BT Sirius/XM-- CD-SB10 Ipod Adaptor-- CD-IU230V HD Radio-- GEX-P10HD Retain Factory Chime etc-- Metra's GMOS-01 GM data bus interface Rear Camera-- ND-BC20PA Retain Steering wheel controls-- PAC SWI-PS