postcg

Ha ha!!! I figured it out. I hooked up the Speed Pulse to the correct wire. I found out the one that the sh*tty installer hooked it to was the one for the reverse sensor , and never hooked up the reverse sensor on the AVIC. So, the Speed Pulse would get a pulse when I would back out of the driveway . Everything is all good now. Thanks for everybody's help. FYI for B6 A4 owner's: The speed pulse wire is the brown/red wire on the GREEN harness on the right side of the instrument cluster.

Thanks for the response. I am trying to verify the VSS wire right now. But I should mention, I have reset the sensor calibrations before, checked the speed pulse in connections status to be zero while in motion, then saw speed pulse count in 3D Calibration status. My guess is that VSS wire is loose and only sends a signal intermittently. I'm gonna check it out. Concerning the A4 information you supplied, I did verify that the speed pulse sensor was attached to the brn/red wire coming from the blu plug form the gauge cluster. Still no speed pulse while in motion. That speed pulse is real ti

Oops!!! I forgot to mention that. Yes, it is ZERO when I'm moving. Sorry I wasn't clear on that.

I am having a problem with Z1. I was too lazy/busy to install it myself, so I had a local shop put it in. Big mistake. Anyway, when I go to Menu>Settings>Hardware>Connection Status, the Speed Pulse is reading "0." I assumed my Speed Pulse wire from the back of the Z1 was not connected properly. The part that confuses me is that when I go to Menu>Setting>Hardware>3D Calibration Status, I get a reading in the Speed Pulse part. WTF? I've tried everything. I reset all the Sensors, Tapped into the VSS wire again (but I'm not sure if it's the correct wire. I tried troubleshooting