vexen1972

too bad I now have two GPS antenna, but it's still working like a champ, love this site..thanks all for the help

Fixed the issue!!, using test mode, I went in a deleted all the gps files, so far so good, had the truck up to 70+ and no reboot...fingers and toes crossed

I have the v2.x..., still need to run the reboot loop fix though

No, not yet, downloading as I type, will do once complete...so will not having the Pink (CAR SPEED SIGNAL INPUT) cause any issues or is it not needed?

Well my new antenna is installed and yet once I go over 15 mph , it starts to reboot........why,why, why ...any suggestions, could it be my vehicle speed sensor, I'm at a lost now... just checked my power harness, i don't have the Pink (CAR SPEED SIGNAL INPUT) could this be the issue?

Yup, just bought one for 23.00, let's see what happens when it gets here

Just figured it out, it's my antenna...great, no GPS. Now to eBay I go to find a replacement antenna

Just installed my AVIC 900BT in my 2010 chevy Tahoe using the PAC OS-4 Radio replacement Interface. Everything worked or seemed to work, here is my issue: when the vehicle is sitting still, it stats up fine, once the vehicle start moving forward, the radio is constantly rebooting until I come to a complete stop. Before I go tearing the whole system down, I would like to know where I went wrong with the installation.

Re: Displaying your current speed New postby JasonH on Sat Apr 11, 2009 8:41 pm It will, for whatever reason, it shows KPH when standing still. so go back into: under settings -> navi settings -> regional settings and change which settings to what value, if i remember right you have more than one option. found it, thanks

under settings -> navi settings -> regional settings just tried that and it did not change to speedometer display to MPH, it's still showing km, is there any other way to have it display MPH while i am driving?

What!! ain't that bout a ... thanks for this very important info. i was not looking forward to screwing with the system ok, did that, thanks, now how do i change it to MPH?

GTIMatt's mod will do this for you. where do i find this mod?

Hello all, I have searched this Forum looking for a way to display my current speed, found some info. but still did not find the answer to the question. I have a AVIC F700BT, with version 2.0 pre installed, I did the mute wire bypass, but now want to be able to display my current speed, especially since my speedometer is somewhat off. thanks for any help