I ran a search of this forum and checked all of the things previously mentioned related to this problem. I installed a reman Avic-D1 in a 1995 Hummer H1 GAS engine (not diesel, because I know that was a problem with another member). The D1 reboots and loses all of its settings after the ignition has been off for more then 60 seconds. I've soldered all of the connections and checked the ground. I hooked a voltmeter up to the wiring harness and it is showing constant power at all times on the BATT wire and the voltage only drops to about 10 volts on start-up. There are no loose wires at the