Roadie00

I'm having a small issue with my unit, and it only seems to be with one road near me. There are two roads that go East/West where I live. One is a major interstate (I64), the other is a state road (State Road 60). When I enter an address that would require me to travel on one of these roads the Nav Unit always selects State Road 60 instead of the interstate. I have played with all of the settings in the Route function of the unit and they all try to use the state road instead of the interstate. It's weird in that in only does this for these two roads. Would this be a problem with the map

Disregard my previous post! I did some additional searches and located a source online which was able to provide me what I needed! Sorry for the useless posts!

I have been looking on the internet and this forum for a solution to a few minor issues (I just recently registered on the forum, but have been searching for a while). I currently have an AVIC-F90BT installed and working in my 2008 Dodge Ram. I did install a backup camera, but wired it so that I have to manually select backup camera. I could not find the Reverse wire behind the dash to hook the unit to. Which is what I am needing help with. Can anyone point me in the right direction as to where the reverse wire is behind the dash? I know I can find it at the tail light, but I would rat

Greetings all! I have been looking around on the forum for about a month now and have found some very good information, much of which I have used to mod my F90BT. I finally have a NAV Radio I enjoy using! Thanks to all for all of the great information on the forum! My current setup is in a 2008 Ram Quad Cab. I currently just have the AVIC-F90BT running 3.0 and some minor mods that I discovered on the forum. I look forward to learning more about the NAV unit and all that this forum has to offer!