mikemac

I've got a 2010 Tahoe LTZ with rear controls, I used the PAC GMVRD harness to keep the rear audio. Headphones still work awesome.

Hey, I just did an install on my 2010 Tahoe with EXACTLY the same components. I mounted my reverse camera above the licence plate on the same piece that the licence plate lights are. Take the time to run the wire with the stock harness. I chose to run it up the passenger side. The only plastic i had to take off there were the 2 door sill pieces (you can just slip the rest of the wire underneath all the interior pieces) . The camera wire will run up to the front passenger door sill and that's where you'll have to put the filter, then it's a piece of cake to the dash. Be careful when p

After talking with Pioneer for the last couple days they are figuring it is just a mapping issue from TeleAtlas. The 920 does do turn by turn where I am and it has the 2010 Maps. I think i'll wait for the update and try it out then.

Turns out, after speaking with Pioneer, that in some areas the turn by turn Nav doesn't work... So it looks like i'm going to have to get a different brand, maybe Kenwood, which has a Garmin system on it that I know works in Northern Canada. Thanks for your help.

Ok i'll give that a shot, thanks for your help.

There's nothing displayed at the top left... And the bar at the top only shows the road that the final destination is on. I have driven the route that i've entered but it doesn't tell me turns. I have to look at the map and follow the line.

No there isn't. I also can't select "Street View" from the Nav view options.

No it does not drive in a straight line. It will calculate a route properly but it does not list the turns on the route. The turns are excluded from the calculated route so the nav system doesn't tell me when there is one coming up. In the manual they are called "Maneuvers" but even with that option turned on they still don't show up. Hopefully that makes a bit more sense.

Hi everyone, I recently installed the AVIC-Z110BT in my Chevy Tahoe and everything works great except part of the Nav system... Whenever I enter any information, whether it's a POI, address or just scroll to a location, the route is calculated as a single road with no turns (yellow maneuver points), so I'm getting no turn by turn directions. I've looked on this forum to see if anyone else has had this issue and couldn't find any similar problems. If I touch route overview however it shows all the turns that SHOULD happen but doesn't relay it onto the map while moving... I did do the Byp